Powerbank made of bamboo, 2,200 mAh Godimer - wooden

External additional bamboo battery, with a loading capacity of 2,200 mAh. Thanks to its small size, easy to carry, with USB and Type-C output and input. Specially developed for laser engraving.

Includes micro USB cables. Complete discharge protection system that increases the life of the power bank. Blocking system for avoiding short circuits.

Constant charge transfer system, corresponding to the capacity of the target device. The battery is specified with a nominal capacity of 2200 mAh.

Materials and handling

Material of execution: bamboo/wheat straw. The external dimensions are 2.5 cm long, 10.1 cm high, 2.5 cm wide.

Then you use the equipment.

The nominal capacity of 2200 mAh describes the built-in battery. How much of it arrives at the end device depends, among other things, on voltage and charging losses; this does not result in a fixed number of complete smartphone charges. For USB-C, check whether the port is intended as an input, output or for both directions according to the product equipment.

The plug form alone does not occupy a fast-charging function.

Questions about use

How many battery charges are possible?

The specified battery capacity is 2200 mAh. No fixed number of complete smartphone charges can be derived from this: device size, conversion losses and simultaneous use influence the actual possible recharging.

Can I order Godimer with or without a logo?

You can also order “Powerbank made of bamboo, 2,200 mAh Godimer” from Mono.Gift without a logo.

Branding position	Max. print size	Branding method
Area 1	8 × 1.7 cm	Laser engraving Pad printing Digital printing
Area 4	8 × 1.7 cm	Laser engraving Pad printing Digital printing
Area 7	8 × 1.7 cm	Laser engraving Pad printing Digital printing
Area 10	8 × 1.7 cm	Laser engraving Pad printing Digital printing
Area 2	5 × 1 cm	Digital printing
Area 5	5 × 1 cm	Digital printing
Area 8	5 × 1 cm	Digital printing
Area 11	5 × 1 cm	Digital printing
Area 3	7 × 1.4 cm	Digital printing
On the side, area 4	7 × 1.4 cm	Digital printing
Area 9	7 × 1.4 cm	Digital printing
Area 12	7 × 1.4 cm	Digital printing

A laser engraving changes the released surface; the visible colour results from the material and is not freely selectable. For a logo in printing inks, one of the printing methods also mentioned can be considered.

For information about the different methods and design options, see our comparison of branding methods. For artwork requirements and any approvals needed, see our ordering process.

Find the right option

You can find more options under Power banks.